IKEA BESTÅ TV storage combination/glass doors instructions

To install the BESTÅ TV storage combination with glass doors, you will need the following tools:
- Screwdriver
- Hammer
- Drill (optional)

The key steps are:

1. Carefully unpack all the components and lay them out according to the instructions.
2. Attach the wall brackets to the wall securely, ensuring they are level.
3. Assemble the TV bench frame, attaching the side panels, shelves, and back panel.
4. Carefully lift and attach the TV bench to the wall brackets.
5. Install the drawers by sliding them into the frame.
6. Attach the glass doors by aligning the hinges and securing them in place.
7. Adjust the door hinges as needed to ensure a proper fit and smooth operation.
8. Route any cables or cords through the designated openings in the back of the TV bench.

Take your time and follow the step-by-step instructions carefully. If you have any issues, refer to the IKEA customer service for further assistance

To help manage the cords running down into the BESTÅ TV storage combination, here are a few suggestions:

Use the cable outlet at the top to route the cords smoothly. There is a dedicated cable outlet designed to allow the cords to run down into the unit neatly. Make sure the cords are threaded through this opening properly.

Consider using cable clips or ties to bundle and secure the cords as they run down the back of the unit. This will prevent them from getting tangled.

You can also look into adding a cable management tray or channel at the back of the unit to further organize and conceal the cords. This will keep them contained and out of sight.

Finally, utilize the cord outlets on the back panel of the TV bench to route the cables through and keep them out of view. This will create a clean, organized look.

With a little cable management, you can easily tame those cords and get your BESTÅ TV storage combination set up just the way you want

The soft-close mechanism for the BESTÅ drawers is a relatively simple installation process that does not require advanced technical skills. Here are the steps:

1. Fully extend the drawer you want to install the soft-close mechanism on.
2. Locate the small plastic clip or bracket on the inside of the drawer side panel. This is where the soft-close mechanism will attach.
3. Take the soft-close mechanism and clip or snap it securely into the plastic bracket on the drawer side.
4. Make sure the soft-close mechanism is properly aligned and secured in place.
5. Close the drawer slowly to test the soft-close function. Adjust the mechanism if needed to ensure smooth, quiet closing.

The entire process should take only a few minutes per drawer. No special tools are required beyond possibly a small flathead screwdriver to gently pry open the plastic bracket. As long as you follow the steps carefully, installing the soft-close mechanisms is a straightforward task

The issue with the soft-closing mechanism on your BESTÅ TV storage combination is likely caused by a few possible factors:

1. Overloading the drawers - Make sure you're not exceeding the maximum load capacity of 22 lb (10 kg) per drawer. Overloading can prevent the soft-close mechanism from working properly.

2. Misalignment of the drawers - Check that the drawers are properly aligned and sliding smoothly on the tracks. Adjust the drawer alignment if needed.

3. Debris in the drawer tracks - Clean the drawer tracks to remove any dirt or debris that may be interfering with the smooth operation.

To fix the issue, try the following steps:

1. Unload the drawers and check the alignment. Adjust the drawer fronts as needed to ensure they are properly aligned.

2. Clean the drawer tracks thoroughly to remove any obstructions.

3. If the problem persists, you may need to replace the soft-close mechanism. This is a relatively simple repair that can be done by following the instructions in the IKEA product manual.

Let me know if these troubleshooting steps help resolve the issue with your BESTÅ TV storage combination